Yaesu FTX-1F HF/50/70/144/430MHz All Mode QRP Portable Transceiver

Tarkkaresoluutioinen 4.3” TFT-värinäyttö.

Yaesu FTX-1 Field

Toiminta-aika 6400 mAh vakioakulla n. 9 tuntia (SSB / 6 W).  Erillisellä virtalähteellä / 12 V akulla lähetysteho 10 W.

Reaaliaikainen kahden taajuuden yhtäaikainen kuuntelu myös samalla taajuusalueella. 3D RF-spektrinäyttö.

USB, LSB, CW, AM, FM, C4FM -modet.  Tekniset tiedot

-SDR Technology and 3DSS (3-Dimensional Spectrum Stream) on a 4.3-inch high-resolution full-color touch display panel 

-Two independent receiver circuits provide true simultaneous dual-band operation, whether in the same band or in 

different bands. For example: SSB communication on HF bands simultaneously with C4FM digital communication 

on V/UHF bands (*HF+V, HF+U, V+V, U+U, V+U, U+V)

-Two loudspeakers ensure clear and powerful audio output

-An optional Automatic Antenna Tuner can be attached to the rear of the transceiver with the 6400 mAh high-capacity 

Li-ion battery pack. The optional Cooling-fan, which is necessary for comfortable FT8 operation, can also be 

combined with the antenna tuner. (All-in-one rear panel design)

-RF front-end and Low Noise Reference Oscillator, enable Phenomenal Multi-signal Receiving characteristics

Effective QRM rejection afforded via High-speed 32-bit IF DSP (YAESU’s renowned interference reduction 

systems: SHIFT / WIDTH / NOTCH / CONTROUR / APF / DNR / NB)

-Compatible with WiRES-X operation

-PMG (Primary Memory Group) function can register and monitor up to 5 frequently used frequencies 

-MAG (Memory Auto Grouping) function enables Memory Channels to be categorized in each band that can be 

quickly recalled by band groups (HF/VHF/UHF/AIR/OTHERS)

-USB ports support CAT operation, audio input/output and TX control

Enabling the 4m band (70-70.5 MHz) on FTX-1F and FTX-1 Optima:

1. Turn the radio off.

2. Press and hold the [MAG (BAND)] and [M>V (MT)] buttons simultaneously.

3. While holding the buttons, turn the radio on and release them when the backlight comes on.

The radio will restart with the new configuration, which includes the 4-meter (70 MHz) band.

You should see "C2(UK)" displayed to indicate the UK-specific settings are active.